Have you seen these fabulous pendant light drum shades at Room and Board? I’ve been drooling over them for years, with all the gorgeous prints and colors. They’re a splurge at several hundred dollars a shade, but they are really beautiful. Go check out all the beautiful and funky prints they have!
As always, I was wondering if I could make something like this myself, and in browsing ideas, I found some great examples, including this one from Laura at Some Kind of Lovely Ride. She did a beautiful job on her shade and had great instructions that helped me conquer my apprehension about this project!
I was so excited to get started, I rushed to the craft store to pick up my supplies and get to work! I stenciled the lampshade in my craft studio and while I was at it, I also stenciled a piece of fabric for a throw pillow. I used Laura’s basic instructions and discovered a few tips along the way, so here’s how it went:
- Stencils – I used Mini Peony and Mini Mums by The Crafter’s Workshop.
- Stencil brushes or sponges – These sponge “pouncers” are inexpensive, easy to use, and washable for reuse.
- Paint – I had a variety of acrylic craft paint around, and I did mix some to get the colors I wanted. It’s optional, but I also added some “textile medium” to my paint, which makes the paint more flexible when dried. This wouldn’t be an issue for the shade, but I thought it would help on the pillow. I mixed the paints in paper bowls.
- Tape – I used painter’s tape to hold the stencil in place and mask off any areas of the stencil I didn’t want to use.
- Tape the stencil securely in place
- Put a small amount of paint on your pouncer. If you load on too much paint, it will run under the stencil and smudge your pattern.
- Lightly dab through the stencil, moving only up and down. Don’t brush side to side, as this will also make paint run under the stencil.
- Carefully remove the stencil and blot the back on a clean piece of paper to remove any excess paint
Adding a color:
- Wait until the first color is completely dry.
- If you are going to overlap designs, like I did, think ahead about which color you want to be “on top” and start with the colors that are on the bottom.
Finishing the fabric:
- This is not necessary for a shade, but for a pillow or other fabric that will be touched and possibly washed, you’ll want to set the paint. When the paint is thoroughly dry, iron the stenciled fabric from the reverse side with a dry iron on medium-high for three to five minutes to set the colors. You can repeat this on the front, laying a thin cloth over the stenciled fabric, so the paint doesn’t stick to your iron.
Here is how the shade looked before:
And here’s the finished shade:
Here’s the finished fabric. I’ve got a lot of pillow projects lined up, so I should work on those soon!
This project is shared at:
<img alt="the gilded hare"